Kormas takes place in the VIII. International “Başkent” Congress On Physical, Engineering and Applied Sciences Proceedings Book with his presentations.

The Başkent Congress, which has hosted a total of 983 (440 Turkish – 779 Foreign) people from 32 different countries in 7 congresses held until today, will be held on 04-06 February 2023 with the participation of 15 different participants in Turkey, Azerbaijan, Netherlands, India, Namibia and the Philippines. 8th International Başkent Science, Social and Health Sciences Congresses were held with 55% foreign participants from the country.

The Congress was held separately in 3 main areas under the name of the 8th International “Başkent” Science, Engineering and Applied Sciences Congress, the 8th International “Başkent” Humanities and Social Sciences Congress and the 8th International “Başkent” Medicine, Nursing and Health Sciences Congress.

Among these fields, at the 8th International “Başkent” Science, Engineering and Applied Sciences Congress, Two presentations, “Investigation of Factors Affecting the Efficiency of Low Power Brushless Motors” and “Investigation of Electric Angle of Hall Sensor in Inner Rotor and Outer Rotor Brushless DC Motors” prepared by our Expert R&D Engineer, Mr. Buğra ER and Prof. Dr. Okan BİNGÖL were made.

In the session moderated by Abdullah BİÇER and coordinated by Nigar EMECEN EZGİN on 04.02.2023, firstly, “Investigation of Factors Affecting the Efficiency of Low Power Brushless Motors”, and secondly in the same session, “Investigation of Electric Angle of Hall Sensor in Inner Rotor and Outer Rotor Brushless DC Motors” presentations by Kormas on was made.

In the study titled “Investigation of Factors Affecting the Efficiency of Low Power Brushless Motors”, the components and power losses in the brushless motor driver are included. This total loss is calculated by considering the energies consumed by the components, as well as the switching frequency, dead time losses and charge losses in the power layer.

In the study on “Investigation of Electric Angle of Hall Sensor in Inner Rotor and Outer Rotor Brushless DC Motors”, the connections between the mechanical angles and electrical angles of Hall sensors in Brushless DC motors with outer rotor 20 stator slots and 18 rotor poles and inner rotor 6 stator slots and 4 rotor poles are applied. shown as. Signal images were taken by placing Hall sensors in different stator grooves, and the connection between electrical angle and mechanical angle was interpreted by sharing the graphics obtained as a result of the tests. 

You can review the VIII. International “Başkent” Congress On Physical, Engineering and Applied Sciences Proceedings Book (1) via the link below.

1. https://drive.google.com/file/d/1oxeIy27ts-HRO8hRSGWQqj5KHOl7nhuk/view?usp=share_link

You can access the studies titled “Investigation of Factors Affecting the Efficiency of Low Power Brushless Motors” and “Investigation of Electric Angle of Hall Sensor in Inner Rotor and Outer Rotor Brushless DC Motors” in the file attachment section.

                        ……………